Performance Comparative Analysis of Monocrystalline and Polycrystalline Single Diode Solar Panel Models using the Five Parameters Method

Authors

  • Rizal Akbarudin Rahman Universitas Negeri Malang, Jl. Semarang No.5, Sumbersari, Kota Malang 65145, Indonesia
  • Aripriharta Aripriharta Universitas Negeri Malang, Jl. Semarang No.5, Sumbersari, Kota Malang 65145, Indonesia
  • Hari Putranto Universitas Negeri Malang, Jl. Semarang No.5, Sumbersari, Kota Malang 65145, Indonesia

Keywords:

Dye-Sensitized Solar Cell, Voltage, Current, Agarwood leaf

Abstract

The use of renewable energy as a source of electricity has increased steadily each year. Unfortunately, Indonesia still has relatively few power plants that utilize renewable energy. Among the available options, solar energy holds the greatest potential, as solar panels can convert sunlight into electrical energy. However, environmental conditions can influence the performance of solar modules and, consequently, the amount of electricity generated. This study evaluated the performance of solar panels using the single-diode model with the Five Parameters method. The method requires solar module specification data, the total radiation absorbed by the module, and ambient temperature. As a single-diode equivalent circuit, the Five Parameters method is considered reliable for predicting solar panel output when input data is limited. The results for monocrystalline solar panels were: Isc = 1.827 A, Imp = 0.662 A, Voc = 18.221 V, Vmp = 15.019 V, and Pmp = 9.955 W. For polycrystalline solar panels, the results were: Isc = 1.926 A, Imp = 0.686 A, Voc = 17.594 V, Vmp = 14.166 V, and Pmp = 9.722 W. Based on these findings, the monocrystalline solar panel was identified as the most efficient and optimized type under natural conditions at Sendang Biru Beach, producing an output power of 9.955 W. Therefore, the establishment of solar power plants in coastal areas such as Sendang Biru Beach could help reduce electricity costs and promote the use of renewable energy.

Downloads

Published

2019-01-09

Issue

Section

Articles